I would look into using route maps. I pulled this from another thread on here. The commands may not be exact but should get you close.
access-list 101 deny ip host 192.168.5.1 host
access-list 101 permit tcp host 192.168.5.1 any eq http
route-map PBR permit 10
match ip address 101
set ip next-hop x.x.x.x
because the first line is a deny it will not be sent the next-hop of x.x.x.x but routed via the normal routing table. The second line for http traffic is a permit and so will be sent to the next-hop ip of x.x.x.x.
Found here : https://supportforums.cisco.com/discussion/10836341/routing-multiple-default-gateways
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...