I have an access point that is requesting DHCP, and a helper statement on the gw for the remote host 10.1.1.150. The request is on standard udp port 67/68, but the firewall only accepts 546/547 at this time. It will be a week before the fw changes are in, so I was wondering if I can implement a NAT that only changes the port.
TO DHCP SERVER:
Source 192.168.1.21 -> 255.255.255.255 udp/67
Source 192.168.1.17(GW) -> 10.1.1.150 udp/546
Is this possible? IOS 12.3.8(YI3) advanced security image on a Cisco871 router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...