can not access internet with cisco 2801 router configure for lea
There are several things in this post that puzzle me.
I agree with Alain that the terminology is not clear. Most of us do understand the term leased line to refer to a serial connection. This post uses the term for an Ethernet. But I can understand that it may not be clear what is the best term to refer to a leased Ethernet connection to Internet and that leased line may sort of fit.
I am also puzzled by this static route
ip route 188.8.131.52 255.255.255.248 184.108.40.206
Why is there a static route for the subnet connected to FastEther0/1? And why does the static route point out to the ISP address?
I am also puzzled why there is NAT at all. The addresses on both interfaces are public routable addresses. There is no indication that there are any private addresses in this network. So what is it that needs to be translated?
Perhaps the original poster can provide some clarification of these questions?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.