Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Can Not Create T3 Multilink on 7613

I currently have two T3 multilinked on 7206vxr and need to move this multilink over to a new chasis (Cisco 7613, IOS 12.2(33) SRC4).

When I try to create the multilink on the 7613 it does not work. I'ev created multilinks before and have never had any issues. Attached is the show tech. Does anyone know why it doesn't work? Any assistance would be greatly appreicated.

  • WAN Routing and Switching
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: Can Not Create T3 Multilink on 7613

Hello David,

>> just so that I understand you correctly. I will have to break the bundle and create seperate /30 connections for each WAN link?

yes this is your only option

Hope to help

Giuseppe

4 REPLIES
Hall of Fame Super Silver

Re: Can Not Create T3 Multilink on 7613

Hello David,

you have

5    0  2 port adapter Enhanced FlexWAN        WS-X6582-2PA

see restrictions for distributed multilink in flexwan configuration guide

Distributed MLPPP is supported only for member links configured at T1/E1 or subrate T1/E1 speeds. Channelized STM-1/T3/T1 interfaces also support dMLPPP at T1/E1 or subrate T1/E1 speeds. Distributed MLPPP is not supported for member links configured at clear-channel T3/E3 or higher interface speeds.

http://www.cisco.com/en/US/docs/routers/7600/install_config/flexwan_config/features.html#wp84027

you need to move to two or three parallel L3 links

Hope to help

Giuseppe

New Member

Re: Can Not Create T3 Multilink on 7613

Hi giuslar,

just so that I understand you correctly. I will have to break the bundle and create seperate /30 connections for each WAN link?

thanks.

Hall of Fame Super Silver

Re: Can Not Create T3 Multilink on 7613

Hello David,

>> just so that I understand you correctly. I will have to break the bundle and create seperate /30 connections for each WAN link?

yes this is your only option

Hope to help

Giuseppe

New Member

Re: Can Not Create T3 Multilink on 7613

As usual Guislar, thanks for your help. Please change your handle to "CiscoGod":-)

392
Views
0
Helpful
4
Replies