11-16-2006 10:00 AM - edited 03-03-2019 02:44 PM
I have a cisco 1721 router. I have t1 configured between two offices. I am getting an up up but can not pink the serial interface from own router therefore can not route between the offices. Can anyone help
11-16-2006 10:21 AM
Hi
Are you getting connected routes in your router , when you execute show ip route command in router.
Few things need to check
1) IP routing enable
or send your configuration.
-Minu
11-16-2006 01:27 PM
Thank you all for your quick replys. I figured out the problem. I was using an external dsu with an interface that had a built in dsu. In the external dsu I split the data lines to be 1-10. I put in the statement "service-module t1 timeslots 1-10" into each serial interface along with making sure my classless route was correct, and I had connectivity. Thanks again, this is my first time using this group.
11-16-2006 10:22 AM
Is this a frame-relay, ppp or hdlc ?
11-16-2006 10:53 AM
Can you show cdp neighbor and get the router on the other end of the serial intf? If so, check your ACLs and make sure icmp is allowed. Even if it is on the actual router you're pinging from...a misconfigured ACL can prevent even local pings.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide