I have a vaio EB2S1E and one router Linksys WRT120N. Both devices have the N wireless standard. When i set the router to Wireless N-only, my notebook cannot conect to it anymore, i see it as a device but after i enter the SSID and password it will not connect. If i leave it to Mixed or Wireless G-only or set it to Wi-Fi Protected Setup the notebook connects fine and i am amble to copy with 2.5 mb/sec
I have posted a picture with the settings, can anyone tell me what am i doing wrong?
PS I have two onboard LAN cards on my PC one Marvell Yukon 88E8001/8003/8010 PCI Gigabit Ethernet Controller and one Marvell Yukon 88E8056 PCI-E Gigabit Ethernet Controller. Is there any difference between them, besides the name? Which one is better to use with my router?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...