Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can't determin model from sh versions

Doing network discovery and need to verify the exact model type for a 75xx router. Can't find it in sh vers or sh diag. Can anyone help?

I can paste in the output of these two commands if that would help.

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: can't determin model from sh versions

How about a "show inventory", usually shows detailed info.

New Member

Re: can't determin model from sh versions

I had a typo, here is the correct configuration:

7507 - RSP's in slots 2 and 3

7505 - RSP's in slot 4

7513 - RSP's in slot 6 and 7

7576 - Same model as 7513 so same configuration.

Regards

9 REPLIES

Re: can't determin model from sh versions

can you post output of both commands?

New Member

Re: can't determin model from sh versions

attached...thx.

Re: can't determin model from sh versions

can you post also " show 7500 " I think this is also a command if not mistaken.

[edit]

Im thinking of 7200 series, show 7500 may not be valid , can you see if you see it by " show tech-support "

Re: can't determin model from sh versions

this must be a 7513 , there are three models in this series 7505 with 4 interface slots, 7507 with 5 configurable interface slots and 7513 with 11, looking at the attached files and slots you have 9 slots being used.

I must admit have not worked with 7500 series yet.. as to what command would show this information remains.. I do not know.

http://www.cisco.com/en/US/products/hw/routers/ps359/products_data_sheet0900aecd800f5542.html

HTH

Jorge

Re: can't determin model from sh versions

How about a "show inventory", usually shows detailed info.

New Member

Re: can't determin model from sh versions

With a sh diag command, you have to determine which slot holds the master and slave, once this is done you will be able to determine wich model of 75xx you are using:

7507 - RSP's in slots 2 and 3

7507 - RSP's in slot 4

7513 - RSP's in slot 6 and 7

7576 - Same model as 7513 so same configuration.

to decode the sh diag output, you can send an email with the content od the sh diag to diag@external.cisco.com or shdiag@external.cisco.com and you will get the output decoded, hope this helps

http://www.cisco.com/en/US/partner/products/hw/routers/ps359/products_installation_and_configuration_guide_chapter09186a00801c63a5.html#wp1038389

New Member

Re: can't determin model from sh versions

I had a typo, here is the correct configuration:

7507 - RSP's in slots 2 and 3

7505 - RSP's in slot 4

7513 - RSP's in slot 6 and 7

7576 - Same model as 7513 so same configuration.

Regards

New Member

Re: can't determin model from sh versions

folks, sh inventory and this listing (also in the data sheet) solved the mystery model number thank you.

New Member

Re: can't determin model from sh versions

Carlos, is this another tool from within the man y tools in the TAC Tools website? like Output Interpreter, etc?

Or do you have to send it to those blind email addresses?

Didn't know this existed, just curious.

136
Views
0
Helpful
9
Replies
CreatePlease to create content