Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Can't read from control socket. Socket error = #10054. FTP ASA

hi,

i have configured FTP server in DMZ zone of the ASA server. i have two public ip addresses a.b.c.d and e.f.g.h when i configured FTP with a.b.c.d it works fine for the inside users and internet users, but when i configured it with e.f.g.h it worked for the inside users but outside users get error message "Can't read from control socket. Socket error = #10054."

My FTP server is LINUX based and is not managed by me

4 REPLIES
Community Member

Re: Can't read from control socket. Socket error = #10054. FTP A

Hi

if you dont mind post your ASA config.

regs

S.Mohan

Community Member

Re: Can't read from control socket. Socket error = #10054. FTP A

hi,

i have attached my configuration file.

thanks

Community Member

Re: Can't read from control socket. Socket error = #10054. FTP A

Hi

e.f.g.h is your ASA External Interface ip.so you cannot able to use that ip in your FTP Server( Static NAT).

static (DMZ,outside) a.b.c.d 10.5.0.5 netmask 255.255.255.255

the above line is your Static NAT of FTP Server.

regs

S.Mohana sundaram

Community Member

Re: Can't read from control socket. Socket error = #10054. FTP A

hi,

sorry that was typing error actually , it was r.s.t.u ip , one thing more when i change static mapping do i need to clear xlate table, may be it was causing problem.

Thanks

1233
Views
0
Helpful
4
Replies
CreatePlease to create content