I am trying to use the Cisco SDM Express Wizard to initially configure a 1812 ISR. During the wizard, at the "Internet (WAN)" page, I am instructed to choose an interface (FE0 and FE1 show up) and click the "Add Connection" button to enter connection parameters (where I assume I would have to enter IP, PPPoE authentication, etc.). However, selecting either FE interface and clicking the "Add Connection" button does nothing and I cannot proceed with the wizard (unless I forego configuring a WAN connection).
I know I can configure it easily through the CLI, but I need to use the wizard this time for demonstration purposes.
Anyone have any ideas?