I can build out both multilinks, assign the serial interfaces to their respective groups, but I cannot get both up/up at the same time. If I were to unplug one set of serials, or shut down one of the Multilinks, the other will then come up. I cannot find anywhere on cisco if there are limitations for a 2801 to handle more than one multlink. Can anyone shed any light?
I have two multilink ppp interfaces running simultaneously on 2801's with no problem. Each has two T1's assigned to it. I know that there are some limits as to what queuing strategy you can use. I have fair-queuing disabled, and am using separate multilink bundle id's. Here is a sample config:
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.