Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cannot configure 6th class in Policy-map - thought limit was 256?

When trying to

build a policy map (of classes with service-policies or HQoS style) I an unable to create any more than 5 class entries.  Is this a limit I can adjust somewhere?

seems no matter what I try  I get the error

% class map my-class-name not configured

on the 6th class in the policy map.

Is there a way around this or a technique of acheiving the same in another manner?

thanks in advance!

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Super Bronze

Re: Cannot configure 6th class in Policy-map - thought limit was

Hi

That's the error you get if you try to add a class-map to a policy-map, wihtout first configuring the class-map at the global level.

Are you sure that's not what you are doing?

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
2 REPLIES
Super Bronze

Re: Cannot configure 6th class in Policy-map - thought limit was

Hi

That's the error you get if you try to add a class-map to a policy-map, wihtout first configuring the class-map at the global level.

Are you sure that's not what you are doing?

Aaron

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
New Member

Re: Cannot configure 6th class in Policy-map - thought limit was

yup, ok I've been staring at this stuff too long.  You are correct, I fat fingered the name.

Thanks

259
Views
0
Helpful
2
Replies
CreatePlease to create content