Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cannot ping interface from GSR to CR Router

Hello,

        I am trying to ping across two Router's one end is GSR and the other end is CR router. According to the cabling guy problem is the Part on the GSR. but i seriously doubt it. But i am just wondering by putting the controller output if you guys can see any indication where port could be bad or some cabling issue.

GSR-#sh controllers gigabitEthernet 15/0/0
========= Line Card (Slot 15) =========
slot=15, port=0
physical port details... slot 0xF bay 0x0 port 0x0 line_state 0x0 context 0x5304CB20
GBIC line_state         00
Lineup is 0x1
FRR configuration is OFF

Interface 15/0/0(idb 0x51EDC3C0)
Hardware is BFLC SPA 10 GE, network connection mode is force
network link is up, loopback type is none
output flow-control is on, input flow-control is on
rx_pause_count=0, tx_pause_count=0, fullduplex=1

HW MAC addr: 0021.5616.2b00, BIA MAC addr: 0021.5616.2b00
hwidb status is 0x18040
hwidb state is  0x4
autonegotiation results: flow control rx TRUE flow control tx TRUE

carrier_delay info: processing_on 0x0, delay_ticks 0x0, up_ticks 0x0 down_ticks 0x0, event 0x1 up_stats 0x0 down_stats 0x0 up_ignored 0x0 down_ignored 0x0

hw statistics


Port0:

  Input  0 bytes, 0 packets, 0 drops, 0 errors
       0 ucast, 0 mcast, 0 bcast
       0 crc, 0 overrun, 0 frames

  Output  0 bytes, 0 packets, 0 errors
       0 ucast, 0 mcast, 0 bcast
       0 underrun

  Rx 0 pkts_64, 0 pkts_127, 0 pkts_255
       0 pkts_511, 0 pkts_1023, 0 pkts_1518
       0 giants, 0 runts, 0 jabbers
       0 fragments 0 collisions
       0 1q_pkts 0 unknown_1q_drops
       0 pause_frames 0 aborts

  Tx 0 pkts_64, 0 pkts_127, 0 pkts_255
       0 pkts_511, 0 pkts_1023, 0 pkts_1518
       0 giants, 0 runts
       0 pause_frames 0 aborts 0 collisions

Link flapped at 0x25104C8F
Link State changed to down 
1.1 FPGA Address : 0xB3000204    Value : 0x10060100
1.2 FPGA Address : 0xB3000204    Value : 0x10060100
2.1 FPGA Address : 0xB3000200    Value : 0x6       
2.2 FPGA Address : 0xB3000200    Value : 0x0       
3.1. Serdes PCS status Register1 (0x230001): 0xFFFF    
3.2. Serdes PCS status Register1 (0x230001): 0xFFFF    
4.1. Serdes PCS status Register2 (0x230008): 0xFFFF    
4.2. Serdes PCS status Register2 (0x230008): 0xFFFF    
5.1.Frequency status status Register (0x238126): 0xFFFF     
5.2.Frequency status status Register (0x238126): 0xFFFF     
6.1.10G Serdes status Register (0x238127): 0xFFFF    
6.2.10G Serdes status Register (0x238127): 0xFFFF    
7.1. Reg (0x238300): 0xFFFF    
7.2. Reg (0x238300): 0xFFFF    
8.1. Reg (0x23fe26): 0xFFFF    
8.2. Reg (0x23fe26): 0xFFFF    
9.1. PHY XGXS status 1 reg(0x240001) : 0xFFFF    
9.2. PHY XGXS status 1 reg(0x240001) : 0xFFFF    
10.1. PHY XGXS status 2 reg (0x240008): 0xFFFF    
10.2. PHY XGXS status 2 reg (0x240008): 0xFFFF    
11.1.PHY XGXS Lane status reg (0x240018) : 0xFFFF     
11.2.PHY XGXS Lane status reg (0x240018) : 0xFFFF     
12.1. reg (0x248009) : 0xFFFF     
12.2. reg (0x248009) : 0xFFFF     
13.1. reg (0x230020) : 0xFFFF     
13.2. reg (0x230020) : 0xFFFF     
14.1. reg (0x230021) : 0xFFFF    
14.2. reg (0x230021) : 0xFFFF    
15.1. reg (0x23820A) : 0xFFFF    
15.2. reg (0x23820A) : 0xFFFF   

Mac port info:

   DeviceID: 0x221911AB
   RevisionID: 0x00000003
   SideBandFC: 0x00000000
   SERDESGlbCntl: 0x40000800
   GlblEPDCntlCfg: 0x00002000
   TxFIFOUrecECCErrCtr: 0x00000000
   RxFIFOUrecECCErrCtr: 0x00000000
   DeviceGlobalRst: 0x00000000
   GlobalCfg: 0x34800000
   PortTest: 0x00000000
   PL4IOGlblStat: 0x00000000
   MACStatus Port0:  0x0000043F
   MACControl0 Port0:  0x00000001
   MACControl1 Port0:  0xB12401D1
   MACControl1 Port5:  0xB1240BD1
   MACControl2 Port0:  0x0D811920
   SERDESCntl Port0:  0x00003C12
   RateLimCntl Port0:  0x00000001
   SysIntMask: 0x00000000
   SysIntCause: 0x00000010
   GOPIntMask0: 0x00000000
   GOPIntCause0: 0x41800002
   GOPIntMask1: 0x00000000
   GOPIntCause1: 0x00000000
   GOPIntMask2: 0x00000000
   GOPIntCause2: 0x00000000
   GOPIntMask3: 0x00000000
   GOPIntCause3: 0x00000000
   CalendarParam: 0x01010101
   SPI4SrcDPDeskew: 0x00010000
   SrcClndrCmd: 0x00000000
   SnkCalSeqPrgm: 0x00000000
   SinkControl: 0x00000000
   SPI4SrcMaxBrst: 0x00040004
   SPI4IntfBrstLen: 0x0003003F
   TxPacketSize: 0x00000000
   RxFullWatermarks: 0x007800C8
   RxFIFOXOnOffFCWtrmrk: 0x0A000800


L2 asic info:

=====================================================

CR-Router Output.

CR-Router #sh controllers tenGigE 0/0/0/4
Operational data for interface TenGigE0/0/0/4:

State:
    Administrative state: enabled
    Operational state: Up
    LED state: Green On

Phy:
    Media type: R fiber over 1310nm optics
    Optics:
        Vendor: CISCO-AVAGO    
        Part number: SFCT-7081Z-CS2 
        Serial number: AGA1523N1D8    

MAC address information:
    Operational address: e8b7.5424.ac21
    Burnt-in address: e8b7.5424.ac21
    No unicast addresses in filter
    Operating in multicast promiscuous mode

Autonegotiation disabled.

Operational values:
    Speed: 10Gbps
    Duplex: Full Duplex
    Flowcontrol: None
    Loopback: None (or external)
    MTU: 4478
    MRU: 4478
    Inter-packet gap: standard (12)

286
Views
0
Helpful
0
Replies
CreatePlease to create content