Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

cannot remove command

Hi,

We have following router config. 192.168.10.25 is static NAT to one public IP address. we use "no" to remove it. However, it cannot remvoe. the command is still there and the "format"is changed. It becomes to:

ip nat inside source static 192.168.10.25 204.1.1.1 route-map <-- the nonat is missing

We cannot delete it. Any idea to delete this commands? please advise

----

!

interface GigabitEthernet0/0

ip address 204.1.1.30 255.255.255.0

ip nat outside

!

!

interface GigabitEthernet0/2

ip nat inside

!

!

!

ip nat inside source static 192.168.10.25 204.1.1.1 route-map nonat

!

route-map nonat permit 10

match ip address 100

!

!

access-list 100 deny ip 192.168.10.0 0.0.0.255 172.16.10.0 0.0.0.255

access-list 100 deny ip 192.168.10.0 0.0.0.255 192.168.20.0 0.0.0.255

access-list 100 permit ip 192.168.10.0 0.0.0.255 any

2 REPLIES
Hall of Fame Super Gold

Re: cannot remove command

How are you trying to remove the NAT statement?

If the statement is in use then you need to remove the translation and then delete

Remove the ip nat inside or the ip nat outside command

Then remove the translations using clear ip nat transaltions and then try to remove the command

HTH

Narayan

124
Views
8
Helpful
2
Replies
CreatePlease to create content