Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cant add t-1 to VWIC-2MFT-T1-DI

i googled the error message but didnt find any useful information. any one ever had this issue before? i lowed the max sessions for conference and transcoding but with no luck. i also maxed out pvdm on the network module (NM-HDV)

EWT_NOC(config)#controller T1 1/1

EWT_NOC(config-controller)#channel-group 0 timeslots 1-24 speed 64

Channel setup failed!!! s:t:c 1:1:0

HDV slot 1 DRAM size 524280 free 66725 need 124992

%Insufficient resources to create channel group

EWT_NOC(config-controller)#

thanks in advance.

2 REPLIES
New Member

Re: cant add t-1 to VWIC-2MFT-T1-DI

"HDV slot 1 DRAM size 524280 free 66725 need 124992 "

It appears that you don't have enough ram to allocate to the interface. Check to ensure SMARTinit is enabled. SMARTinit automatically adjusts interface memory allocations on router boot.

Router(config)#no memory-size iomem

Smart-init will be enabled upon reload.

If this doesn't solve the problem you'll probably need to buy additional RAM for your router.

New Member

Re: cant add t-1 to VWIC-2MFT-T1-DI

i'll try it and post the results.

thanks!

428
Views
0
Helpful
2
Replies