The ">" prompt that appears after the break sequence: is it just a character or is it a prompt of a command line? The 2500 series routers have had very limited ROMMON and used mostly cryptic commands to perform the necessary tasks. For example, if you actually arrived to the ROMMON in 2500, the commands to ignore the stored config would be
Can you please try this? Also, try sending the Break sequence every 5 seconds or so during the entire root bootup from the power on. Some routers were "sensitive" to the Break sequence only in a certain time frame.
Since it boot all the way, that is good news. This means your flash card is good.
I agree with Peter that some times you have to try the break sequence multiple time and not just once. (I know it should work in the first 30 seconds), but that is not always the case. If that does not work, try just the break key by itself and see if you can get to Rommon.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.