i have a directly connected network (T-1) 172.19.1.1 and from the router i can ping only some devices on the 172.16.1.0 network. i have a route in the routing table for the 172.16 network. i can ping their defaut gateway which is 172.16.1.1 but i cant ping my laptop 172.16.1.60.
i replaced the router on the 172.19.1.0 network last week.
Your original post gave the address of your laptop as 172.16.1.60. The routing table you supplied show this is connected to FastEthernet0/0.10. So it might be helpful if you would post the config of that interface.
It would also be helpful if you would check and see if the IP address and MAC from your laptop show up in the ARP table of this router. This would demonstrate a basic level of communication - or would explain why communication is not happening.
You have described the problem as not being able to ping to your laptop. You have not indicated whether you are having problems getting to things from your laptop. Perhaps you can clarify whether your laptop can access network resources.
As other have pointed out one possibility of the problem might be a firewall running on your laptop which is not allowing pings. Can you verify whether there is a firewall running on your laptop.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.