Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Capture controller flap with syslog?

Anyway that I can capture/log a T3 controller that is flapping? The flap is fast enough that the serial interface does not go down and is not captured in the log. On my console I get the following when the controller flaps.

Oct 13 16:56:43.946: %CONTROLLER-5-UPDOWN: Controller T3 2/0, changed state to down

Oct 13 16:56:44.946: %CONTROLLER-5-UPDOWN: Controller T3 2/0, changed state to up

I am trying to log this.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Capture controller flap with syslog?

enable "logging console" and then that will send any message you see on the console to your syslog server.

3 REPLIES

Re: Capture controller flap with syslog?

enable "logging console" and then that will send any message you see on the console to your syslog server.

Community Member

Re: Capture controller flap with syslog?

Thanks. That was easy.

Re: Capture controller flap with syslog?

Great, glad it helped. I guess we can mark this post resolved.

168
Views
0
Helpful
3
Replies
CreatePlease to create content