Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cat 6009 : System drawing more power than the power supply rating

Hi Folks,

I have Cat 6009 with 6.4 sw version.

firstly, one of my power supply not being recongnized and though redundant power supply is being noticed by the system but continuously giving below messege.

2007 Jun 25 18:51:26 %SYS-5-PS_REMOVE:Power supply 2 has been removed

2007 Jun 25 18:51:28 %SYS-5-PS_INSERT:Power supply 2 has been inserted

2007 Jun 25 18:51:28 %SYS-2-PS_OK:Power supply 2 okay

2007 Jun 25 18:51:28 %SYS-1-SYS_ENABLEPS: Power supply 2 enabled

2007 Jun 25 18:51:55 %SYS-2-PS_FAIL:Power supply 2 failed

main cause is below error:

2007 Jun 25 14:40:33 %SYS-1-SYS_OVERPWRRTNG:System drawing more power than the power supply rating

While searching on Cisco found to be problem related to hw and sw compitiblity but same configuration of hw and sw is working fine with other setup.

Sup : WS-X6K-SUP1A-2GE

Sw : cat6000-sup.6-4-6.bin

PS : WS-CAC-4000W-INT

Kindly provide a solution.

Thanks,

Hardik..

2 REPLIES
Hall of Fame Super Gold

Re: Cat 6009 : System drawing more power than the power supply r

Suggest you contact the TAC for this issue because seeing the PS "flapping" is not normal.

Re: Cat 6009 : System drawing more power than the power supply r

Try reseating both power supplies and see if that helps.

HTH

Sundar

126
Views
0
Helpful
2
Replies
CreatePlease to create content