08-06-2006 02:16 PM - edited 03-03-2019 01:34 PM
I'm studying for my CCNA. The WestNetLearning study materials I have indicate that I should be using a CLI to establish the ip & default gateway, but my Catalyst 1900 goes straght to a menu (instead of the cli I was expecting). Even my router simulation software places me into a menu w/o the ability to get to the CLI. What have I missed?
08-06-2006 02:34 PM
Hi,
The Cat1900 allows you to access the CLI from the menu. Simply hit "K" and you will be taken to the CLI.
Hope that helps - pls do rate the post if it does.
Paresh
08-06-2006 05:12 PM
When it starts up, say no to entering set up mode and then you can go to CLI from there.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide