I am having trouble with changing the configuration for the VRF on a Catalyst 4507R+E using SUP7-E. No matter which Supervisor is used, if the default VRF is Mgmt-vrf it cannot be changed. Therefore, I cannot successfully ping the gateway of my device or beyond.
The commands to configure VRF would work, but it will not override the default VRF. Output reads "Management interface VRF can not be changed." How am I supposed to get around this?
Extra note: If I use mgmtVrf or Mgmt-intf then I can ping successfully. The VRF name by default seems to be specific to the IOS version being used. Please help.
If you stick to OOB Mgmt port your must use the factory-bound vrf. But you can choose another physical port or a Vlan interface for managing the switch and you can assign the global vrf or your custom vrf:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...