Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
Bronze

CCS Router 1000V - Applying License

Hi All,

I have installed the above virtual router. I've also purchased a 3yr subscription 100Mbps license for it, but not sure how to apply my key to the router. It doesn't seem to be the same commands used when applying licences to physical routers.

Anyone done this before?

Thanks

1 REPLY

CCS Router 1000V - Applying License

Hi,

I think you mean the CSR1000v? It is running IOS-XE.

This document describes the steps:

http://www.cisco.com/en/US/docs/routers/csr1000/software/configuration/licensing.html#wp919868

Changing the Maximum Throughput Level

The license must be activated and the EULA accepted before changing the maximum throughput level.

Command or Action

Purpose

Step 1

enable

Example:

Router> enable

Enables privileged EXEC mode.

Enter your password if prompted.

Step 2

show platform hardware throughput level

Example:

Router# show platform hardware throughput level
The current throughput level is 50000 kb/s

Displays the current maximum hardware throughput level.

Verify the current settings.

Step 3

configure terminal

Example:

Router# configure terminal

Enters global configuration mode.

Step 4

Cisco IOS XE Release 3.10S and later:

platform hardware throughput level MB
{10 | 100 | 1000 | 25 | 250 | 50 | 500}

Cisco IOS XE Release 3.9S:

platform hardware throughput level
{10000 | 25000 | 50000 | eval-only}

Example:

Router(config)# platform hardware throughput level 500

Changes the maximum throughput level for the Cisco CSR 1000V.

If you select eval-only, the system will only check the evaluation license.


Note In Cisco IOS XE Release 3.9S, the throughput level values are expressed in Kbps.


Step 5

exit

Example:

Router(config)# exit

Exits configuration mode.

Step 6

show platform hardware throughput level

Example:

Router# show platform hardware throughput level
The current throughput level is 50000 kb/s

Displays the current maximum hardware throughput level.

Verify that the maximum throughput level has been updated.

There is also a section on changing the license when the router boots up.

Daniel Dib
CCIE #37149

Please rate helpful posts.

Daniel Dib CCIE #37149 Please rate helpful posts.
108
Views
0
Helpful
1
Replies
CreatePlease to create content