Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CDP Neighbour show itself

Hi All,

Could someone please help me, I have a router connected to a BT (British Telecoms) LES circuit via interface Gig0/0/0. The problem I'm having is when I do show cdp neighbour it shows itself and not the switch on the other end. Local router is W-UK-WL-ER3002-ISP-02 and the remote switch is SW-TCHX-AD4


W-UK-WL-ER3002-ISP-02#sho cdp nei
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
                  S - Switch, H - Host, I - IGMP, r - Repeater

Device ID        Local Intrfce     Holdtme    Capability  Platform  Port ID
W-UK-WL-ER3002-ISP-02.westfield-london.c
                 Gig 0/0/0          179         R S I     2851      Gig 0/0/0
W-UK-WL-ER3002-OUTDMZ-02
                 Gig 0/0            150          S I      WS-C3750G Gig 1/0/1

However on the switch end (SW-TCHX-AD4) when I do sho cdp neighbour I do see the router (W-UK-WL-ER3002-ISP-02)

SW-TCHX-AD4#sh cdp nei

Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge

S - Switch, H - Host, I - IGMP, r - Repeater, P - Phone

Device ID Local Intrfce Holdtme Capability Platform Port ID

W-UK-WL-ER3002-ISP-02.westfield-london.c

Gig 5/10 141 R S I 2851 Gig 0/0/0

Has anyone ever had such a problem?

Thanks

Brett

Everyone's tags (2)
1 REPLY
Hall of Fame Super Silver

Re: CDP Neighbour show itself

Hello Brett,

there is a L2 provider in the middle so all this can come from service provider equipment.

if SP devices are cisco they may need to be configured for L2 tunneling to carry CDP if provider is using 802.1Q tunneling.

in any case this is an emulation the real neighbor of your device is the service provider node.

Hope to help

Giuseppe

2079
Views
5
Helpful
1
Replies
CreatePlease to create content