Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CEM Dejitter Buffer

I came across a CEM port whose Dejitter buffer size is set to 60 and the Dejitter buffer level max was 64....How is that possible?

3 REPLIES
Hall of Fame Super Silver

Re: CEM Dejitter Buffer

Hello James,

Setting the Dejitter Buffer Size

To specify the size of the dejitter buffer used to compensate for the network filter, use the dejitter-buffer size command. The configured dejitter buffer size is converted from milliseconds to packets and rounded up to the next integral number of packets. Use the size argument to specify the size of the buffer, in milliseconds. The range is from 1 to 500 ms; the default is 5 ms.

see

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/SRC1/76cfgcep.html#wp1585001

so the value is to be seen as msecs and I share your concerns

Hope to help

Giuseppe

New Member

Re: CEM Dejitter Buffer

So the Max level size is a rounded number of packets where as the Buffer size is a Manually entered number??

Hall of Fame Super Silver

Re: CEM Dejitter Buffer

Hello James,

being a command expressed as msecs of traffic you cannot compare directly the two numbers:

60 ms of traffic should be in packets much more then 64 and this should explain why that CEM configuration is possible

Hope to help

Giuseppe

516
Views
0
Helpful
3
Replies