Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

CH E1

can any one helpout to me?

How to do configure the channalaized E1 on Cisco 7206 and in that multichannel card is there

2 REPLIES
Hall of Fame Super Silver

Re: CH E1

Hello Asi,

if you are using a channelized E3 multichannel E3

you need to go though two levels hierarchy:

define and configure E3 controller

define and configure each child E1 controller

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_data_sheet09186a0080091d25.html

or if you are using a multichannel E1

http://www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/voice/MIX-mc_t1.e1_install_config/3608conf.html

Hope to help

Giuseppe

New Member

Re: CH E1

Hi Sasi,

To sum it up, you must define the controller for channelized E1/T1 (E1 in your case)

"controller E1 1/0

channel-group 30 timeslots 1-31 "

//where 1 is your row#,0 is your module #

"interface Serial3/1:30"

// So only difference in channalized E1 and serial E1 is that you have to define 30 channel's grouping, rest is same as for the serial"

177
Views
0
Helpful
2
Replies
CreatePlease to create content