ā06-14-2012 06:22 AM - edited ā03-04-2019 04:40 PM
The problem is the following:
The card controller e1 - VWIC2-1MFT-G703 is necessary to configure it for data communication, links in 64k,ie using a 1 time slot for each of the E1 link (serial interface).
But I can only create a channel-group, this topology need to create more than one (1) channel or a channel-group with multiple interfaces.
When I try to create a second channel, the device gives me the following message:
% Channel-groups per port limit Exceed
% Insufficient resources to create channel-groups
The IOS version is 15.1 (4) M15
CISCO1941/K9
VWIC2-1MFT-G703
I need to apply this setting
controller E1 0/0/0
channel-group 1 timeslots 1-2
channel-group 2 timeslots 3-4
channel-group 3 timeslots 5-6
Can you recommend another type of compatible router for this application
Thank you.
Best Regards,
ā06-14-2012 06:34 AM
Hi,
You likely have "clock source independent" configured there. Per the following guide, when independent clocking is configured, the controller will support only one channel group and no voice applications:
http://www.cisco.com/en/US/docs/ios/12_2/12_2z/12_2zj/feature/guide/gthwecan.html#wp1068671
Kind Regards,
Ivan
**Please grade this post if you find it useful.
ā06-14-2012 09:36 AM
Somebody now the maximum number of data channel-group supported by VWIC2-1MFT-G.703?
and CISCO1941/K9 ?
Please check the configuration could apply this attached.
Best Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide