02-20-2018 06:49 AM - edited 03-05-2019 09:57 AM
Hello everyone,
I need to change the MAC address on a physical interface of my switch.
The command is not aviable in the interface configuration mode.
The switch is model is :
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 28 WS-C3650-24TS 03.03.04SE cat3k_caa-universalk9 INSTALL
Is it because this modèle does not support this feature ?
Thanks for the help
02-20-2018 09:27 AM
Hello
you can configure a static MAC address mapping to the interface
macaddress static xxxx xxxx interface xxx
res
paul
02-21-2018 12:47 AM - edited 02-21-2018 01:08 AM
Hi Paul,
Thanks for your help.
Correct me if i'm wrong, but this command is for creating a static entry in the mac address table.
So it says "to join this mac address, go through this interface" right ?
I need the switch to use a specific mac address on this interface because our ISP use mac filtering.
Every traffic not in the specific mac address range is dropped.
02-21-2018 01:12 AM
02-21-2018 01:24 AM
I t's a WS-C3650-24TS :
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 28 WS-C3650-24TS 03.03.04SE cat3k_caa-universalk9 INSTALL
02-21-2018 01:49 AM
As far as I understand, it's a switchport.
I can't create sub-interface.
04-29-2021 06:44 AM
I'm trying to do something similar, did you ever get an answer to your question?
12-28-2022 10:49 AM
I am using a virtual switch, but you can add the mac address directly to the interface:
And here is the output from it's neighbor
Hope that helps!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: