I have 2 Cisco 3750X in a stack and i want to change mtu size from 9000 to 1500
ISCSI-SWITCH(config)#system mtu jumbo 1500 Changes to the system jumbo MTU will not take effect until the next reload is done ISCSI-SWITCH(config)# ISCSI-SWITCH#copy run start Destination filename [startup-config]? Building configuration... [OK]
Do I have to reboot the whole stack at once or can i reboot a single slot using:
ISCSI-SWITCH#reload slot switch_member_number
so that I can use my redundency because I can not down with with servers
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...