Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing the .bin file on a 2811 Router

In order to change the .bin file on my 2811 router can I just delete c2800nm-advsecurityk9-mz.1243h.bin and replace it with c2800nm-advanterprisek9-mz.124-6.T8.bin?

Is that allI have to do to reload it?

This is the first one I have had to reload the IOS on.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Changing the .bin file on a 2811 Router

Yes, you can delete it with:

erase flash:/c2800nm-advsecurityk9-mz.1243h.bin

You could also keep it there in case there is a problem with new image. You would copy the file to flash and then go into config mode and type:

boot system flash:c2800nm-advanterprisek9-mz.124-6.T8.bin

This will tell the router what image to boot (otherwise it will boot the first image in flash).

HTH and please rate.

1 REPLY

Re: Changing the .bin file on a 2811 Router

Yes, you can delete it with:

erase flash:/c2800nm-advsecurityk9-mz.1243h.bin

You could also keep it there in case there is a problem with new image. You would copy the file to flash and then go into config mode and type:

boot system flash:c2800nm-advanterprisek9-mz.124-6.T8.bin

This will tell the router what image to boot (otherwise it will boot the first image in flash).

HTH and please rate.

526
Views
0
Helpful
1
Replies