Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Changing the metric of a External OSPF route

Hi All,

I want to change a metric of a external type-1 ospf route. But I can't make it work.

The route I want to change metric is 10.198.14.150/32 and it is redistributed from a static route in another neighbor router (R2).

This is my configuration.

------

! R2

router ospf 200

redistribute static metric-type 1 subnets

network 10.0.0.0 0.0.255.255 area 0

ip route 10.198.14.150 255.255.255.255 10.0.1.21

------

! R1

router ospf 200

network 10.0.0.0 0.0.255.255 area 0

distribute-list route-map GATO-MAP in

ip access-list standard GATO-ACL

permit 10.198.14.150

route-map GATO-MAP permit 10

match ip add GATO-ACL

set metric 1000

route-map GATO-MAP permit 20

---------------------------------------

I know that the problem is related to external routes because if I try to change the metric of internal route using the same configuration it works.

Below is the configuration that works:

------

R2

router ospf 200

redistribute static metric-type 1 subnets

network 10.0.0.0 0.0.255.255 area 0

int loopback20

ip add 10.198.14.150 255.255.255.255

------

R1

router ospf 200

network 10.0.0.0 0.0.255.255 area 0

distribute-list route-map GATO-MAP in

ip access-list standard GATO-ACL

permit 10.198.14.150

route-map GATO-MAP permit 10

match ip add GATO-ACL

set metric 1000

route-map GATO-MAP permit 20

1 REPLY
Hall of Fame Super Silver

Re: Changing the metric of a External OSPF route

Hello Paulo,

try to use the same route-map but directly in the redistribute command:

router ospf 200

redistribute static metric-type 1 subnets route-map GATO-MAP

Hope to help

Giuseppe

200
Views
0
Helpful
1
Replies
CreatePlease to create content