Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Channelised E1 status reset

I have a E1 card on a 3660 router. It show reset. I've tried to troubleshoot with SP in vain. Anone with an idea where else to look?

1 REPLY
Gold

Re: Channelised E1 status reset

Just had one of these happen recently. Never did find out exactly what reset means.

I still suspect the one of the vendor changed to frammed from unframmed for a period of time but no proof. 3 different telco involved.

We put a hard loop plug toward the router to verify the cabling in the building. It came up/up looped like normal and the reset never came back after we reattached the circuit a couple hours later.

Not that I would say that a hard loop plug will fix your problem it is easy to try.

When I tried to look this up all i found about reset was related to PRI cards.

178
Views
5
Helpful
1
Replies