Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Channelised STM.

Dear Freinds,

I need to configure Channelised STM on Cisco 7613 Router (7600-SIP-200) 1 Port with respect to E1.

Requesting to please guide me or share config.

Regards

6 REPLIES
Hall of Fame Super Silver

Re: Channelised STM.

Hello Sudhir,

channelized interfaces require to configure a hierarchy:

first the underlying STM-1 controller has to be initialized then you need to configure the tributary controllers until you reach the E1 level.

see

http://www.cisco.com/en/US/docs/ios/12_4/interface/configuration/guide/h_stm5.html

this is for a PA in a flexwan, but the config should be similar for the SPA in the SIP.

this is the right link

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/76cfstm1.html

Hope to help

Giuseppe

Hall of Fame Super Blue

Re: Channelised STM.

Giuseppe

Congratulations on the purple star :-)

Jon

Hall of Fame Super Silver

Re: Channelised STM.

Hello Jon,

thanks so the threshold is at 4500 points

don't worry I will stay here at purple level for a while :-)

Best Regards

Giuseppe

Hall of Fame Super Blue

Re: Channelised STM.

"thanks so the threshold is at 4500 points"

Yes not quite sure why it says 3750 as it has always been 4500.

"don't worry I will stay here at purple level for a while :-)"

No worries, it does seem to take forever to get out of purple tho :-)

Jon

New Member

Re: Channelised STM.

Thanks a lot.!!!

But please clear this line as i am bit confused "first the underlying STM-1 controller has to be initialized then you need to configure the tributary controllers until you reach the E1 level".

Specially for tributary Controllers.

regards

Hall of Fame Super Silver

Re: Channelised STM.

Hello Sudhir,

in simpler words:

you need to configure a controller that represents the whole STM-l link.

Then following the documentation you need to define some Virtual Containers (payload objects) until you can define a controller E1.

To be able to define an E1 you need first to define a VC that carries inside a T3 DS3 rate and then an E1

refer to the second link in my first post

Hope to help

Giuseppe

117
Views
0
Helpful
6
Replies