Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Channelized DS3

Is it possible to aggregate multiple T1 channels on a channelized DS3?

For example can I use mlppp to aggregate 3 T1s from Site A to a channelized DS3 at Site B?

Thanks!

3 REPLIES
Purple

Re: Channelized DS3

Hi,

I'm pretty sure that is possible since each of the channels on the channelised DS3 results in a separate serial interface. Therefore, you should be able to include those serials in a MLPPP group.

Hope that helps - pls rate the post if it does.

Paresh

New Member

Re: Channelized DS3

According to the spec sheet of the PA-MC-T3 it is *not* supported...

http://www.cisco.com/en/US/products/hw/modules/ps2033/products_module_installation_guide_chapter09186a00801125e3.html

"Aggregation of multiple T1 lines is not supported." Maybe I am misreading this or they are referring to something else? I hope so...

-Rob

Purple

Re: Channelized DS3

Rob,

I think what they mean by that is that you cannot create an interface that spans more than one T1. That would not be a reference to MLPPP, specifically..

Having said that, it's not something I've tried personally.

Paresh

236
Views
0
Helpful
3
Replies