Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Check IP/packets in "Default" class

I'm wanting to clean up the default class-map. At the moment the key apps are not grouped into a manual class-map & fall under the "default" class.

It is concerning that during congestion key apps have to scrap for bandwidth. I'm looking to distinguish key applications & move them into existing class-maps.

My proposal is to match on destination IP addresses.

The proposed router config looks like this:-

ip access-list extended CAT1_APPS_ACL

remark *** Category 1 Applications -  Destination IP's ***

permit ip any host 1.1.1.1

permit ip host 1.1.1.1 any

!

class-map match-any EXISTING_CLASS-MAP

match access-group CAT1_APPS_ACL

!

policy-map EXISTING_OUT_POLICY

class EXISTING_CLASS-MAP

  set dscp cs3

!

int ***

service-policy output EXISTING_OUT_POLICY

Other than creating a span session is there a way to view relevant IP details within the default class? I need to verify/create a baseline of what is currently visible in the default class,

then post implementation check again to ensure they've been migrated to the EXISTING_CLASS-MAP.

To add, we dont have netflow either.

Any thoughts are appreciated.

Everyone's tags (1)
3 REPLIES
Hall of Fame Super Bronze

Check IP/packets in "Default" class

There isn't a way to detail what falls under the default class-map.

Your idea should work.

Regards

Edison

New Member

Check IP/packets in "Default" class

Thanks for your reply Edison.

I have tried this today & can see matches under the CAT1_APPS_ACL & I also see pkts incrementing under my class-map too. (sh policy-map int *** output class EXISTING_CLASS_MAP)

This is evidence enough that these key apps no longer fall in the default class

Hall of Fame Super Bronze

Check IP/packets in "Default" class

Great, thanks for the post back.

117
Views
0
Helpful
3
Replies