I have a WAN setup with T1's between four remote sites. I use a combination of WIC-1DSU-T1 and VWIC-2MFT-T1 cards for the links. If I have a problem with the WIC cards I enter the command 'sh service-module' and it brings up a small block of text showing errors, line up time, etc.
Now I have a T1 down that is using a VWIC card and the 'sh service-module' doesn't work on it. When I try it tells me there is no service module on the hardware. Is there a way to see the same type of info for the VWIC card as I can see for the WIC card with the 'sh service-module' command?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...