I have a client that has a small office of about 15 employees and is using comcast for ISP with an Eth handoff. I am needing some assistance reccomending equiptment for this user. These are the requirements.
a) 48 port switch with POE (for his IP phones as well as 2 future AP's)
b) Router using Cisco IOS as well as ability for control multiple Access Points
c) possible WLC or Router with built in one.
d) 2 seperate SSID, one for office workers (hidden) and one for visitors and using seperate VLans of course.
I am looking for any reccomendations for a router, switch, WLC (or router with built in WLC), AP's.
I was thinking a 2900 series router with a NME-AIR-WLC6-K9; however I am hearing that the 3850 can do wireless??
I was also looking at some of the 800 series and 1920s as well....
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...