First of all congratulations to everyone for the great forum...
I am receiving that message in my router... I have searched into the forum but still not really convinced about the reason... my thoughts now point to memory problem... What do you guys think about it ?
Thanks in advance!!
Aug 3 17:30:17 GMT: %SYS-2-CHUNKBADMAGIC: Bad magic number in chunk header, chunk 0 data 65630318 chunkmagic 602087A8 chunk_freemagic 64AC0C90
I am glad that you have resolved this. But in case of such error messages you can always check this with TAC to understand if there is a software issue involved. As Donald mentioned, this is a case of memory corruption in the chunk memory header. Good job in finding the solution
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...