05-17-2006 08:07 AM - edited 03-03-2019 12:43 PM
Hello All,
This is a real rookie question but I have tried configuring my 871 router via the CLI and for some reason it does not work. what are the basic commands that I need to get this router working?
I configured the IP address, subnetmask, default route and nat but still nothing. Any suggestions?
05-17-2006 09:14 AM
If you are not very familier to CLI, I would recommend to use the Cisco Express SDM WIzard to configure it
Cisco 870 Series Integrated Services Routers for Small Offices
http://www.cisco.com/en/US/products/hw/routers/ps380/products_data_sheet0900aecd8028a976.html
SDM
05-18-2006 06:51 AM
I think the SDM is not all what it could be and there is a lot of overhead I think. I have configured the router via the CLI line and everything is working now. Thanks for your suggestion.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide