Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 11500 Series Content Switch - Host Header

I have a Cisco 11500 series content switch. I have a website that has multiple websites that use the same IP address but use host header to differenciate between the sites.

Can the content switch be configured to access a site by sitename (www1.xyz.com or www2.xyz.com) instead of by ip address?

1 REPLY
Silver

Re: Cisco 11500 Series Content Switch - Host Header

You can specify URL name by following configurations

config)# owner customer

(config-owner[customer])# content gzip

(config-owner-content[gzip])# vip address 192.168.77.40

(config-owner-content[gzip])# protocol tcp

(config-owner-content[gzip])# port 80

(config-owner-content[gzip])# url "/*"

(config-owner-content[gzip])# add service server3

(config-owner-content[gzip])# active

NOw if you would share load between the servers you can configure that by following command

" dnsbalance roundrobin "

There is also more options aslo. Deafault is round robin load balancing.

If you have any queries please get back to me.

We will again seat resolve the same.

Regards,

Dharmesh Purohit

165
Views
0
Helpful
1
Replies