Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Cisco 1700 Series router Bonding T1's (using 2 WICs)

Hey guys,

My corporate network is separated into two subnets by two 1600 Series routers and a point to point T1. My users in the remote location are outgrowing the bandwidth of the T1. I need to increase the bandwidth. What would be the best way to do this? I have two 1700 series routers with two modular slots each with 2 CSU/DSU WICs. Is it possible to bond the T1's together running CEF on the routers to get them a 3Mbit pipe back to corporate? I dont have any fiber available at the location.

Thanks all.

1 ACCEPTED SOLUTION

Accepted Solutions
Silver
6 REPLIES
Silver
New Member

Re: Cisco 1700 Series router Bonding T1's (using 2 WICs)

Thanks. I have configured NxT1s before. I just didnt know if these routers could handle it.

New Member

Re: Cisco 1700 Series router Bonding T1's (using 2 WICs)

i have done this a few times with 2 T1s on a 1700 series with no issues.

Regards,
Steve
Please rate all helpful posts.
New Member

Re: Cisco 1700 Series router Bonding T1's (using 2 WICs)

Thanks.

New Member

Re: Cisco 1700 Series router Bonding T1's (using 2 WICs)

Would you happen to have a sample config? If not I will figure it out.

New Member

Re: Cisco 1700 Series router Bonding T1's (using 2 WICs)

Olorunloba posted the link to the Multilink PPP configuration guide earlier.

Regards,
Steve
Please rate all helpful posts.
565
Views
0
Helpful
6
Replies
CreatePlease to create content