01-04-2007 09:57 PM - edited 03-03-2019 03:15 PM
Hi to all,
Can you please help me restore my cisco 1751 router to default settings. I enabled the "no service password-recovery" & now I forgot the enable password.
I've tried the procedure that cisco website provided but unfortunately I have no luck.
The CTRL-BREAK combination doesn't work on Hyperterminal. I found another way that states "press ctrl-break when Image text-based is decompressing.... but I cannot do this procedure because when my router boots up, there is no text displays. It will display the banner & asking for the password.
Please help me on this. I need to configure the router as soon as posible.
Thanks!!!!!
Regards
Raymond
01-04-2007 10:01 PM
check if this URL give you some clue.
rate if it does ...
01-05-2007 06:45 AM
Set your Hyperterminal baud rate to 1200 and reboot the router. press the space bar while the router is booting.
Then change to hyperterminal to 9600 baud..
1200 baud and a space bar is the same as sendng a break...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide