Can you please help me restore my cisco 1751 router to default settings. I enabled the "no service password-recovery" & now I forgot the enable password.
I've tried the procedure that cisco website provided but unfortunately I have no luck.
The CTRL-BREAK combination doesn't work on Hyperterminal. I found another way that states "press ctrl-break when Image text-based is decompressing.... but I cannot do this procedure because when my router boots up, there is no text displays. It will display the banner & asking for the password.
Please help me on this. I need to configure the router as soon as posible.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...