Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cisco 1800

When setting up an 1811 and a 1200AP. I have configured 3 Vlans 1, 11, 21 on the AP and router. With the Vlans being the default-router for 3 DHCP scopes. Is this the best solution or is there a better one?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Cisco 1800

The default-router should be the 1811 router's IP address under each of those Vlan interfaces. Yes - that's the best solution.

2 REPLIES
Hall of Fame Super Bronze

Re: Cisco 1800

The default-router should be the 1811 router's IP address under each of those Vlan interfaces. Yes - that's the best solution.

Community Member

Re: Cisco 1800

My next question would be can I make subinterfaces for Fastethernet 0. ie...

F0.1

F0.2

put the default router ip address to these interfaces. Make the Vlans=no ip address.

I am attaching the configs for my AP and Router. I would like someone to check these for efficiency and VPN LAN access.

Your assistance will be much appreciated.

Thanks

By the way, I have one WAN IP supplied by DHCP.

298
Views
0
Helpful
2
Replies
CreatePlease to create content