I would recommend you to configure the router to be a vpn terminator then deploy all clients to use cisco remote vpn clients. what do you need to have? You need to have a correct IOS and a cisco vpn client software to do so.
If you want all clients to remote from the outside world then you need to have public ip addresses for all clients one-by-one. Why? because a remote desktop will use tcp/3389 so all clients will use the same ports it's not possible to use one public ip address to do PAT in the same port. In short you need 6-10 public ip addresses to do so.
So the remote vpn client should take into account by you guys.
After going through the tool it recommneds using 124-15.T4 unfortunetley when I use that ios the wireless does not work anymore it gives me invalid power levels which unfortunelty no one so far knows why.
The way they do it, is they use lets say they have a public ip 184.108.40.206 the add a number afterwards for each workstation and have the router forward that to the specific workstation. 220.127.116.11:100 goes to pc1 18.104.22.168:101 goes to pc2â¦.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...