Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 1811 sub-interfaces - vlans

Is it possible to configure subinterfaces on a Cisco 1811? I have the need to connect a device to an 1811 switch port in say - vlan 200, I also need to add an IP address for this VLAN and use it as the default gateway for other devices in the same VLAN. In order to do this I was thinking along these lines

1.) Connect the device to one of the swtch ports on the 1811 and add the port to vlan 200.

2.) Connect the WAN interface and configure subinterfaces for the VLANs that will be connected to this device. This WAN interface connects to a layer 2 network.

3.) Create a sub-interface to be used as the default gateway for devices in VLAN 200 enable dot1q 200 on the interface.

See the attached network digram as an example.

Is this a valid setup with the 1811 routers?

Any advise would be appreciated.

2 REPLIES
Silver

Re: Cisco 1811 sub-interfaces - vlans

Hi ,

The following document may help you in configuring the vlans.

http://www.cisco.com/en/US/products/ps5853/products_configuration_guide_chapter09186a00804582b6.html#wp999406

Thanks,

satish

Re: Cisco 1811 sub-interfaces - vlans

Hi

You can create VLAN (SVI) instead of subinterfaces..

you can check this link out for more info..

http://www.cisco.com/en/US/products/ps5853/products_configuration_guide_chapter09186a00804582b6.html#wp999406

regds

853
Views
0
Helpful
2
Replies