Look I have an 1812 fixed router. Is it possible to configure it to connect to the Corporate Network over ATM or F/Relay network, without NAT? My corporate network and the remote sites are all using unregistered private IP, so I think I do not need NAT here. Basically I need the remote site subnet to communicate to the Central site subnet as I have done with routers with serial WAN interfaces like the 1700.
I have an STM1/OC3 link from my 7200 on the central site to the ATM network and they do F/relay to the remote sites. What is the right configs in this case? Is it PPPoe or PPPoATM with or witout NAT.??
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...