I have an 1841 router at a remote site that does not show the user name and password prompt when the modem is connected. Only a flashing cursor.
Using our intranet I can telnet to the router, then telnet thru the AUX port, I can configure the modem and get the proper responses back. I can send text by typing "hi mom" from the router to the modem and I can read and send text back through the modem back to the router.
I just can not get the login prompt to show.
The modem is a Hayes H08-15328c with the init string AT&F0Q1E0S0=1S37=9&K0&D0&W. All init string profiles are set to default before this init string is applied. This init string is the only one we can get the modem to connect on a regular basis. It is right out of Cisco documentation for the Hayes Accura modem.
Hayes has sent 6 strings to try, only one connects, but gives the same results just a flashing cursor.
The cable is an RJ-45 to RJ-45 rolled cable pin 1 is 8 on the other end I have tested the cable. I have the same modem adapter that 20 other working routers use successfully. There config is almost identical.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...