Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

CISCO 1841 Configuration

Hi i have to configure a ILL of Bandwidth 512(1:4) so please help me on how to go about it.

The router is Cisco 1841 with one WIC.

What protocol should be used.

3 REPLIES
New Member

Re: CISCO 1841 Configuration

Hi,

What WIC is it? 1841 supports only a few modules of WIC cars.

Justin

New Member

Re: CISCO 1841 Configuration

hi please help me in configuring a Cisco 1841 router with ILL.

This will be PPP connection and fo/0 of router will be connected to the firewall while the serial port will be terminating at ISP Modem.

I think this is simple PPP at serial port but i am still not clear on the Ethernet Port connected to Firewall.

Please help.

Re: CISCO 1841 Configuration

Hi Omeshwar

You just need to key in the ip adress provided by the SP to which you are getting connected..

interface serial 0/0

ip address x.x.x.x y.y.y.252

encapsulation ppp

!

About configuring your local lan totally depends on the ip addressing block being assigned by your SP.

If you are getting a public ip block for your local lan you can configure up the same onto your ethernet port which connects to your PIX firewall may be via a switch or through a cross cable..

regds

339
Views
0
Helpful
3
Replies
CreatePlease to create content