i have Cisco1841 router which fails to boot up. The router gets hangs after self decompressing the image. the router is getting stuck after the comment "Would you like to enter the initial configuration dialog? [yes/no]: " Pls let me know whether whether this is IOS issue or a flash issue.
More likely an IOS issue than a flash issue. Some random thoughts / questions... Did this router and IOS ever boot up before? Did you just try to upgrade the IOS? Do you have any other IOS' in flash that you could boot from?
I haven't done it on a 18xx but if you can get to rommon issue the "sysret" command. The output might clue you in on why its failing. Even if it does you're probably looking at an IOS re-install at the very least.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...