Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Cisco 1841 WAN Auto-reconnect option?

IOS: 12.4(4)T8

Hi, We have the Cisco 1841 running. Recently out ADSL line has disconnected a few times. So we basically just reboot the router to reconnect again. However is there a way to configure the router to auto-connect when the WAN line goes down? via Telnet even?

Thanks!

5 REPLIES
Hall of Fame Super Gold

Re: Cisco 1841 WAN Auto-reconnect option?

It should reconnect automatically.

Please post here "show dsl interface".

New Member

Re: Cisco 1841 WAN Auto-reconnect option?

Hi,

The output is as follows in attachement.

Yes I would have thought it should re-connect when connection is lost - but does not seem to as I have to turn it off and turn it off/on for the Router to connect to the WAN again.

Hall of Fame Super Gold

Re: Cisco 1841 WAN Auto-reconnect option?

Try firmware 3.0.33 from ftp://ftp.cisco.com/pub/access/800/

The file need renaming as explained in the related document.

New Member

Re: Cisco 1841 WAN Auto-reconnect option?

I noticed version 4.10.9 as well : would that not be a good one to load?

Hall of Fame Super Gold

Re: Cisco 1841 WAN Auto-reconnect option?

No, because it's for different hardware.

160
Views
0
Helpful
5
Replies
CreatePlease to create content