Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cisco 1841 with T1 and Cable Modem

We are using a Cisco 1841 with a T1 on the serial and the Cable Modem on FE0/0. We need to get the config to recognize automatically if one goes down, then the other takes over. Does anyone know if this is possible?

1 REPLY
Hall of Fame Super Gold

Re: Cisco 1841 with T1 and Cable Modem

Hi, that would be your configuration example:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a00808d2b72.shtml

Hope this helps, please rate post if it does!

817
Views
0
Helpful
1
Replies
CreatePlease to create content